Table of Contents
Advertisement
Figure 46. Flash power module installation into bracket
Step 2.
Position the flash power module and bracket assembly onto the chassis, where the tabs on the
bracket pass through the corresponding holes in the chassis. Move the assembly as shown until it
is secured onto the chassis.
Figure 47. Flash power module and bracket assembly installation onto chassis
Step 3.
Connect the flash power module cable to the RAID adapter.
Install a front system fan
Use this information to install a front system fan.
"Read the
installation
Guidelines" on
page 54
ThinkSystem ST250 Setup Guide
66
"Power off
the server for
this task" on
page 86
"ATTENTION:
Static Sensitive Device
Ground package before opening"
on page 55
Advertisement
Table of Contents
