Step 1.
Position the server cover on the chassis so that the rail on the bottom of the server cover engages
the bottom rail on the chassis. Align the tabs on the server cover with the corresponding holes in
the top edge of the chassis; then, pivot the server cover to close it.
Figure 61. Server cover installation (1)
Note: Before you slide the cover forward, ensure that all the tabs of the cover engage the chassis
correctly. If all the tabs do not engage the chassis correctly, it will be very difficult to remove the
cover later.
Step 2.
Slide the server cover to the front of the chassis until it snaps into position.
ThinkSystem ST250 Setup Guide
84