Redundant Power Supply - Lenovo ThinkSystem ST250 Setup Manual

USB tape drive
Figure 22. Cable routing for the USB tape drive
Cable
Power cable
1
Signal cable
2
Note: Ensure that all cables are routed through the correct cable clips.

Redundant power supply

Use the section to understand the cable routing for the redundant power supply.
Notes:
• Ensure that all cables are routed through the correct cable clips.
• When installing front fan 2, the cabling highlighted by the red circle may interfere with the installation. If
this happens, push the cabling downwards and neatly tuck them under front fan 2.
ThinkSystem ST250 Setup Guide
36
From
Power connector on power cable
Signal connector on the tape drive
To
Optical drive power connector on system
board
Internal USB 3.0 connector on the system
board