Serial Download - Enterasys SSIM-H2-02 Installation And User Manual

The console will display the download activity while the software is transferred
over the network by counting received blocks. When the software has been
transferred, you will see the following messages:
Network download complete. Now transferring to TS
Module(s), please wait...
Download of TS firmware complete - TS module(s) being
reinitialized...
Warning: If you use Telnet as a manager console, download activity will not be
displayed.
The software image is then programmed into the FLASH memory on the module.
The software image remains in memory until it is replaced. When the software
installation is complete, the module is started for normal operation, and the
following message is displayed:
Press <RETURN> to continue...
Note: Remember that new module software is active immediately after it is
downloaded, but to activate the module's software you must restart the switch.

Serial Download

1. From the main menu, select Download Upload.
2. Select Serial Link Download.
3. Select TS Firmware Download.
4. Using your terminal software, transfer the software image to the SSIM-H2-02
with the X-Modem protocol. The transfer may take several minutes, depending
on your terminal emulator baud.
The software image is then programmed into the FLASH memory of the module,
and will remain there until it is replaced. When the software installation is
complete, the module is started for normal operation and the following message is
displayed:
Press <RETURN> to continue...
SSIM-H2-02 Fast Ethernet - Translational Switch SmartStack Interface Module Installation and User Guide
9
Installation