Table of Contents
Advertisement
3. When the desired operational mode for the port is displayed, use the
arrow keys to highlight the SAVE command at the bottom of the
screen.
4. Press ENTER. The message "SAVED OK" displays.
3.5.2
Assigning a VLAN ID
The Port Assignment Configuration screen also enables the user to set
each port's VLAN ID (PVID) by stepping through a list of all configured
VLANs. To assign a VLAN ID to a port in this manner, perform the
following steps:
It may be necessary to use the NEXT and PREVIOUS
NOTE
commands to page through the available ports. For
instructions, refer to Section 3.5.3, Paging Through the Port
List.
1. Use the arrow keys to highlight the VLAN ID field for the port
combination you wish to change.
2. Use the SPACE bar or BACKSPACE key to step sequentially through
the previously configured VLAN ID numbers. Only existing VLAN
IDs will be displayed.
New VLAN IDs must be created with the functions available on
NOTE
the Device/VLAN Configuration screen, discussed in
Section 3.4.
3. When the desired VLAN ID is displayed, use the arrow keys to
highlight the SAVE command at the bottom of the screen.
4. Press ENTER. The message "SAVED OK" displays.
802.1Q VLAN User's Guide
Port Assignment Configuration Screen
3-17
Advertisement
Table of Contents
