Command Types - Linkcom DoorPhone User Manual

Table of Contents

Advertisement

WRITE ALARMON
+420cc..c
WRITE ALARMOFF
+420cc..c
CAL AT+CSQ
CAL AT+CPBR=x
CAL AT+Č C LK= <time>

5.1. Command types:

READ – command to read the parameters.
CLR – command to erase phone numbers from SIM card.
CAUTION! When you use SMS for numbers erasing then don't forget that one ADMINx number
must stayed! Otherwise remote settings will not be possible (necessary to make new initialization).
INIT – Initialization. During the first setting when SIM doesn't includes any ADMINx number, it is
necessary to put such number on the SIM card. It is done by SMS with INIT command. The SMS can be
sent from any number. When SIM card already has at least one number with name ADMINx the
command is ignored.
WRITE – command to save the parameters.
CAL – after command CAL, you can put any « AT command » used by the GSM module (for example:
module reset, time setting etc.). Those commands please use with appropriate knowledge only! It can
cause blocking of whole unit!
Linkcom France
11 rue du Soleil Levant 92140 CLAMART
x=1 : ON
Savings of number for SMS « ALARM ON » (input grounding)
Savings of number for SMS « ALARM OFF »
(input disconnection)
Signal strength level
Info about number saved on position x
Setup time in GDI <time>
Format <time>= yy/MM/dd,hh:mm:ss±zz
yy – year (00-99)
MM – month (01-12)
dd – day (01-31)
hh – hours (00-23)
mm – minutes (00 – 59)
ss – seconds (00 – 59)
±zz – time zone (-47..+48) hours
Copyright © 2011 – Linkcom – All rights reserved
18

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DoorPhone and is the answer not in the manual?

Table of Contents