Table Of Sms Commands - Linkcom DoorPhone User Manual

When all parameters are setup, click to the save button to save the setting on GSM DoorPhone.
Return from programming mode to monitor mode (restart of GDI) :
When you click on Run button, the behavior of GSM DoorPhone is the same like during power supply
connection (tones, eventually voice messages).

5. Table of SMS commands

SMS command
READ STAT
READ PAR
READ JMENO
CLR JMENO
INIT ADMIN1 +420cc...c
SET REL1 ON
SET REL1 OFF
SET REL1 ON xx
SET REL2 ON
SET REL2 OFF
SET REL2 ON xx
WRITE JMENO
+420cc...c
WRITE PAR VOLIN:x
WRITE PAR VOLOUT:x
Linkcom France
11 rue du Soleil Levant 92140 CLAMART
Descriptions
Reading the status (firmware, time, relays status etc.)
Reading of all setup parameters
Reading of phone number for NAME
Erasing phone number for NAME
Initialization – first GDI setting to configure the ADMIN1
number
Activation relay 1
Deactivation relay 1
Activation relay1 for xx minutes (xx=00 -99)
Activation relay 2
Deactivation relay 2
Activation relay 2 for xx minutes (xx=00 -99)
Saving of phone number under NAME
Saving of microphone loudness [x=1-7]
Saving of speaker loudness [x=1-7]
To return to monitor mode, click on "Run"
button. Program detects the GSM DoorPhone
runs the same way like stop:
Copyright © 2011 – Linkcom – All rights reserved
Default
4
4
16