Power On - Enterasys Vertical Horizon VH-2402-L3 User Manual

Figure 2-2B. Installing the switch on an equipment rack

Power on

The VH-2402-L3 switch can be used with AC power
supply 100-240 VAC, 50 - 60 Hz. The power switch is
located at the rear of the unit adjacent to the AC power
connector and the system fan. The switch's power
supply will adjust to the local power source
automatically and may be turned on without having any
or all LAN segment cables connected.
After the power is on, the LED indicators should
respond as follows:
All LED indicators will momentarily blink. This
blinking of the LED indicators represents a reset
of the system.
The power LED indicator will blink while the
Switch loads onboard software and performs a
9033693-01 38