Factory Defaults - Enterasys Vertical Horizon VH-2402-L3 User Manual

used to prevent their occurrence, and if that failed, limit
their scope. However, with the advent of VLANs,
switches are now able to limit broadcast domains
better and cheaper than routers. The VH-2402-L3
switch has broadcast sensors and filters built into each
port to control broadcast storms.
IP Routing
IP is responsible for getting packets to the destination
specified in the destination address. The task of
determining how to get a packet from the source to the
destination is referred to as routing.
The VH-2402-L3 allows the creation of IP subnets and
can perform IP routing between them. Each IP subnet
corresponds to an IEEE 802.1Q VLAN, previously
defined on the switch.

Factory Defaults

Table 1-1 lists the default settings for the switch
configuration parameters. Each parameter can be
changed via the console menus or Telnet.
Parameter
Load Mode
Switch Operation Mode
Configuration update
Firmware update
Configuration file name
Firmware file name
Out-of-band baud rate
RS232 mode
IP address
Subnet mask
Default Gateway
9033693-01
Table 1-1. Factory Default Settings
Default Value
Ethernet
Layer 2
Disable
Disable
None
None
9600
Console
10.90.90.90
0.0.0.0
0.0.0.0
33