Usb Mobile Dongle Connection - ABB Ability Cassia X1000 Installation Manual

2.7

USB mobile dongle connection

Mobile network can be used with a specific USB dongle. Additional PoE injector is needed
for power supply (see 2.1 Prerequisites for installation on page 5), supported USB dongle
and a SIM card are needed.
Insert the USB dongle with SIM card to USB port at the bottom of the gateway. PIN query
needs to be disabled from the SIM card.
From the Gateway Basic Page select:
Connection Priority: 3G/4G (fw 1.4.3) / Cellular (fw 2.1.0)
-
USB Dongle Type: select correct dongle type used
-
Type the Access Point Name (APN) which the SIM carrier is using
-
Type the username and password for the APN if needed
-
Press Apply at the bottom of the screen.
Reboot the gateway by removing the power supply for a few seconds and then
reconnecting it.
!
NOTE! With a USB dongle the gateway needs to be in place where there is a good network
coverage. In case of weak signal strength, an extension USB cable or additional external
antenna for USB dongle might be needed.
If a WIFI modem is used, insert the modem to USB port at the bottom of the gateway and
follow the 2.6 WIFI connection section instructions.
!
For supported USB dongle modems, please consult the Cassia User Manual. Please note
that some countries may have regulations which may forbid the usage of certain types of
hardware providers (e.g. Check if Huawei can be used in the US)
DOCUMENT ID
9AKK107046A4620
© Copyright 2021 ABB. All rights reserved.
Figure 11 Mobile network configuration
REV.
K
AB B ABI LIT Y™ SM ART S ENSO R BLU ETOOTH ® G AT EWAY
DATE
November 2021
LANG. PAGE
EN 16/23