ABB Ability Cassia X1000 Installation Manual page 21

Traceroute tool (fw 2.1.0):
This tool helps with pinpointing where on network are the biggest delays in
communication. Each hop has three packets sent and three response delays, thus
you could detect exactly which part of the packet journey is the slowest.
This tool can be found in the local configuration page, under the Other tab in the
Debug Tools section of the page.
The fields must be completed as shown below, then click Start.
It will take ~10 seconds for the result to be shown.
Scanning for Bluetooth devices:
A correct gateway placement can be checked by scanning the Bluetooth devices
within the gateway's range. The gateway location or orientation needs to be
changed if all desired Smart Sensors are not visible for the gateway or if the Smart
Sensor is showing weak signal level.
To enable the scanning, the router mode needs to be changed. This is done in the
Basic Page. Change the mode from "AC Managed Router" to "Standalone Router".
Gateway will automatically reboot and is operational again within 30 to 60
seconds.
DOCUMENT ID
9AKK107046A4620
© Copyright 2021 ABB. All rights reserved.
Figure 17 Traceroute tool
REV.
K
AB B ABI LIT Y™ SM ART S ENSO R BLU ETOOTH ® G AT EWAY
DATE
November 2021
LANG. PAGE
EN 21/23