Network Configuration - Firmware 2.1.0 - ABB Ability Cassia X1000 Installation Manual

2.3.2
Network configuration – Firmware 2.1.0
The values in the first section of the Basic page are similar to firmware 1.4.3, but with
some extra options that the newer firmware brings:
!
Router Mode: AC Managed Router
-
Tx Power: 20
-
Statistics Report Interval: 5 minutes
-
AC Server Address: gw.smartsensor.abb.com
-
AC Server Address for China: gw.smartsensor.abb.com.cn
-
AC-Router Protocol Priority: MQTT
-
Enable OAuth2 Token For Local API: OFF
-
Remote Assistance: ON
-
Connection Priority in 2.1.0 firmware is similar to firmware 1.4.3, only the naming of the
three connection types have changed:
Wired for PoE and LAN connections.
-
Wi-Fi for WIFI connection.
-
Cellular for mobile USB dongle connection.
-
If Cellular connection is used, the option Recovery Action must be set to ON.
!
This option enables the gateway to attempt a reboot of the 3G dongle when it is not being
able to provide a network connection anymore.
If all the information has been filled as shown above and the Wired, Wi-Fi or Cellular sec-
tions are configured according to your network specifications, please reffer to 2.9 Veri-
fying the configuration to check if the connection has been successfully set-up.
DOCUMENT ID
9AKK107046A4620
© Copyright 2021 ABB. All rights reserved.
REV.
K
AB B ABI LIT Y™ SM ART S ENSO R BLU ETOOTH ® G AT EWAY
DATE
November 2021
LANG. PAGE
EN 10/23