Usb Mobile Dongle Connection - ABB Ability Cassia X1000 Installation Manual

2.7

USB mobile dongle connection

Mobile network can be used with a specific USB dongle. An additional PoE injector is
needed for power supply (see 2.1 Prerequisites for installation on page 5), supported USB
dongle and a SIM card are needed. Make sure to connect the gateway using an ethernet
cable to the port labelled as "PoE", on the injector.
Insert the USB dongle with SIM card to USB port at the bottom of the gateway. PIN query
needs to be disabled from the SIM card.
From the Gateway Basic Page select:
Connection Priority: 3G/4G (fw 1.4.3) / Cellular (fw 2.1.0)
-
USB Dongle Type: select correct dongle type used
-
Type the Access Point Name (APN) which the SIM carrier is using
-
Type the username and password for the APN if needed
-
Press Apply at the bottom of the screen.
Reboot the gateway by removing the power supply for a few seconds and then
reconnecting it.
The Recommended Dongles for industrial environments are the following:
- MTCM2-L4G1-B03-KIT for Europe (LTE/CAT4)
- MTCM-LNA3-B03-KIT for US/Canada (LTE/CAT1)
DOCUMENT ID
9AKK107046A4620
© Copyright 2021 ABB. All rights reserved.
Figure 12 Mobile network configuration
REV.
L
AB B ABI LIT Y™ SM ART S ENSO R BLU ETOOTH ® G AT EWAY
DATE
August 2022
LANG. PAGE
EN 18/29