Reset; Fixture Information; Operations In Automatic Mode; Master/Slave - ProLights EclGalleryProfile FC User Manual

RESET FACTORY
Selezionare questa funzione per ripristinare l'unità alle impostazioni di fabbrica:
• To activate RESET FACTORY display press the button MENU so many times until shows RESET FAC-
TORY, and press the button ENTER to confirm.
• Press ENTER button to confirm the selection.
• Press the MENU button to go back or to meet the waiting time to exit from the setup menu automati-
cally.

3. 10 FIXTURE INFORMATION

To view all the information on the device, proceed as follows:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the icon Information, then press the ENTER but-
ton to enter the next menu.
• Press the UP/DOWN button to scroll through the menu, then select one of the following information
and press the ENTER button to display it.
- Fixture Time - Through the Fixture Time function you can display the operating time of the projector.
- Temperature - Through the Temperature function can be displayed the temperature inside the fixture,
near the lamp. The temperature can be displayed in degrees Celsius or Fahrenheit.
- Software Version - Through Software Version function you can display the currently installed software
version.
• Press the LEFT button repeatedly to exit the menu.

3. 11 OPERATIONS IN AUTOMATIC MODE

MASTER SLAVE
Press the UP/DOWN button to scroll through the menu, select Master/Slave and press ENTER to confirm your
choice.
• Press the UP/DOWN button to select the mode of operation:
- Master, if the unit is connected in series with other units and it acts as the Master;
- Slave, if the unit is not connected to other units.
• Press the ENTER button to confirm your choice.
EFFECTS
The unit independently runs through its show. Before you send an automatic program you need to set the
drive as Master/Alone:
• Press the ENTER button to access the main menu.
• Press the UP/DOWN button to scroll the menu, select the Effects icon, then press the ENTER button to
enter the next menu.
• Press the UP/DOWN button to select the mode of operation: Effects 1, Effects 2, Effects 3, Effects 4, Effects 5
• Press the ENTER button to confirm your choice.
• Press the LEFT button repeatedly to exit the menu and save changes.
The unit will go into automatic mode by executing the program automatically.
STATIC MODE
This fixture has the ability to accept custom static color settings. Access these chases via the control panel
on the back of the fixture.
• Press the button MENU so many times until the display shows STATIC, then press the button ENTER.
• Select Fixed Color through the buttons UP/DOWN, then press the button ENTER.
• Set the colors R, G, B, W, GB, RB, RG, RGB, RW, GW, BW, RGW, RBW, GBW, RGBW, through the buttons UP/DOWN,
then press the button ENTER.
PROLIGHTS - EclGalleryProfile FC
13