IDTECK Star 505R Quick Install Manual page 2

2. Setup Hardware
2.1 Backup Battery setup and Hardware Initialization
2.1.1 Set up the switch located in the upper-left on the back of the device from 'OFF' to 'ON' as the picture below.
2.1.2 Connect those Pink and Cyan wires with the Black wire and then turn the power on.
2.1.3 The message "Initialize OK?" will be shown on the LCD.
2.1.4 If "1" on the keypad is selected, the message "Initialize END Turn OFF Power.." will be shown on the LCD.
Turn the power off.
Initialize OK?
0: NO
2.1.5 Disconnect those 3 wires (Black, Pink and Cyan).
3. Setup Controller parameter
STAR 505R [F1]
01/01 00:00:15
Start Display
Key '4' or '6': Left/Right
Key '2' or '8': Up/Down
ENT: Change or Enter
ESC: Cancel
☞ In the case of SR505, press <0> key (Default setting "0000000000"+ENT)
10 times to enter the SETUP MENU.
Enter "1" Key
1: Yes
Enter the Master No. + <ENT>
(Default value : 00000000 + <ENT>)
Initialize END
Turn OFF Power...
2
Quick Install Guide
READER1 MODE
RF ONLY
Enter into setup mode