Adjusting Fence - Grizzly G0771Z Manual

Adjusting Fence

There are three main adjustments for the fence:
(1) square, (2) height, and (3) clamping pressure.
Keep in mind that these adjustments are intercon-
nected and some trial-and-error may be needed
to achieve satisfactory results.
Tools Needed
Wrench 19mm ................................................... 1
Hex Wrench 6mm .............................................. 1
Machinist's Square ............................................ 1
Fence Squareness and Height
The fence face must be square to the table in
order to produce accurate cuts. The fence is
adjustable with two set screws where the fence
slot sits in the front rail (see Figure 117).
Also, the fence should be adjusted evenly above
the table to ensure it does not drag across the
surface as shown in Figure 118.
Knurled Lock Nuts
and Set Screws
Figure 117. Location of lock nuts and set screws
for adjusting fence squareness and height.
(Side View)
/ " Gap
1
16
Front Set Table
Screws
(1 of 2)
Figure 118. Fence height is adjusted by two
front set screws and rear bearing shaft.
-66-
To check/adjust fence squareness and height
to table:
1.
2.
Qty
90° Square
3.
Fence
Rear
Bearing
Shaft
DISCONNECT SAW FROM POWER!
Place square on table against face of fence
(Figure 119) to check if fence is square to
table.
— If fence is not square to table, proceed to
Step 3.
— If fence is square to table, skip to Step 4.
Figure 119. Example of checking fence
squareness to table.
Loosen knurled lock nuts and adjust set
screws (Figure 117) on top of fence bracket
to ensure fence face is 90° to table. Tighten
lock nuts when fence is square to table.
Model G0771Z (Mfd. Since 01/21)
Fence
Table