Grizzly G0771Z Manual page 64

Setting 45° Stop
DISCONNECT SAW FROM POWER!
1.
Raise blade as high as it will go, then tilt it
2.
towards 45° until it stops and cannot be tilted
any more.
Place a 45° square against table and blade
3.
so it contacts blade evenly from bottom to
top, as shown in Figure 107. Make sure a
blade tooth does not obstruct placement of
square.
45° Square
Figure 107. Checking blade at 45°.
— If blade is 45° to table, then no adjust-
ments need to be made. Proceed to
Step 8.
— If blade is not 45° to table, you will need
to adjust 45° limiting block. Proceed to
Step 4.
4.
Remove rear access panel.
Model G0771Z (Mfd. Since 01/21)
Blade
Table
5. Loosen (2) M5-.8 x 10 cap screws in 45° limit-
ing block (see Figure 108).
45° Limiting
Block
Figure 108. Location of 45° limiting block.
Tilt blade away from 45° by about 5°, so there
6.
is room for limiting block to move.
Adjust 45° limiting block according to how far
7.
off blade was from 45°, then recheck blade
and repeat adjustment as necessary until
blade stops at 45°, then tighten cap screws
and replace rear access panel.
Make sure tilt indicator arrow points to 45°
8.
mark on scale. If it doesn't, adjust indicator
arrow as described on Page 60.
x 2
-61-