Table of Contents
Advertisement
Blade Alignment
If the blade contacts the table insert when raised
or tilted, the blade must be aligned by moving the
table.
Tools Needed
Wrench 14mm ................................................... 1
To adjust the blade by moving the table:
1.
DISCONNECT THE SAW FROM POWER!
2.
Loosen the three table mounting bolts (Page
51) and adjust the table until the blade does
not contact the insert. Tighten all the mount-
ing bolts.
3. Make sure the blade does not contact the
table insert when raised or tilted. Recheck
parallelism of the blade to the miter slot (see
Page 51). Adjust as necessary until the blade
does not touch the insert.
Adjusting Fence
The rip fence included with your Model G0605X/
G0606X Table Saw is designed to provide excel-
lent ripping accuracy when properly adjusted.
There are three main adjustments to concern
yourself with: square, parallelism and clamping
pressure.
Tools Needed
Hex Wrench 4mm .............................................. 1
Hex Wrench 6mm .............................................. 1
Machinist Square ............................................... 1
Square
1.
Place a machinist's square on the table
against the side of the fence.
—If the square does not remain flush against
both the fence and the table, adjust the
nylon screws (Figure 84) on top of the
fence bracket until the fence and table are
square.
G0605X/G0606X Extreme Series 12" Table Saw
Qty
Clamping Pressure
The fence clamping mechanism has been adjust-
ed at the factory to provide the right amount of
clamping pressure to hold your fence securely.
To adjust the fence clamping pressure:
1.
Loosen the fence lock handle.
2.
Remove the fence from the saw and adjust
the sets screws shown in Figure 85 equally
on the rear side of the front bracket.
3.
Replace the fence and check the clamping
strength. Re-adjust until proper pressure is
ensured.
Qty
Figure 85. Set screw adjustments.
-53-
Advertisement
Table of Contents
