Adjusting Fence - Grizzly T30945 Owner's Manual

10. Use rip fence to align splash hood mounting
bracket to blade (see Figure 49).
Rip Fence
Figure 49. Bracket aligned with rip fence and
blade.
11. Tighten screws loosened in Step 9.

Adjusting Fence

The factory has made all the necessary adjust-
ments on your machine, but the rip fence may
get knocked loose during shipping or eventually
loosen over time.
If the rip fence will not securely lock to the table,
the cam in the locking mechanism may need to be
tightened. If you experience difficulty sliding the
fence across the width of the table, the fence set
screws may need to be adjusted.
Items Needed
Hex Wrenches 2, 3mm ................................1 Ea.
Tightening Cam
1.
DISCONNECT MACHINE FROM POWER!
2. Remove miter guide from rip fence and
unlock and remove rip fence from table.
Model T30945 (Mfd. Since 12/19)
3. Loosen cam screw shown in Figure 50.
4. Tighten cam by turning it towards lock lever
(see Figure 50).
Mounting
Bracket
Blade
Figure 50. Cam and cam screw location.
5.
Test cam by locking rip fence to table. Tighten
cam screw to secure when satisfied.
Adjusting Fence Set Screws
1.
DISCONNECT MACHINE FROM POWER!
2. Adjust set screws shown in Figure 51 to
adjust rip fence movement.
— Loosen set screws to allow rip fence
— Tighten set screws to cause rip
Qty
Figure 51. Rip fence adjustment set screws.
3. Test adjustment by unlocking rip fence and
sliding it along table width. Adjust set screws
until satisfied.
Cam Screw
to glide more easily across table.
fence to glide less easily across table.
Cam
x 2
-31-