Grizzly G0771Z Manual page 24

Insert (2) M8-1.25 x 16 hex bolts into bottom
6.
slot on left end of fence rail (see Figure 18).
These will be used later for mounting the
switch.
Figure 18. Hex bolts for mounting switch.
Press end cap into left end of front fence rail
7.
(see Figure 19).
Figure 19. Left end cap on front fence rail.
Orient fence rail so scale faces you. Slide (8)
8.
M8-1.25 x 30 hex bolts into open slot (see
Figure 20).
Scale
Figure 20. Hex bolt positioned in front fence rail
slot.
Model G0771Z (Mfd. Since 01/21)
Align hex bolts in fence rail with holes in
9.
table, then insert bolts into table. Be sure
scale on fence rail faces up. Hand tighten (8)
M8-1.25 hex nuts onto hex bolts. Do not fully
tighten yet (see Figure 21).
x 2
x 8
Figure 21. Mounting front fence rail.
10. Install switch onto hex bolts from Step 6
using (2) M8-1.25 hex nuts and 8mm lock
washers (see Figure 22).
11. Install rear fence rail on rear of table using
(8) M8-1.25 x 25 cap screws, as shown in
Figure 23. Secure outer four cap screws with
M8-1.25 hex nuts.
x 8
Slot
Figure 23. Rear fence rail mounted.
x 2
Figure 22. Switch installed.
x 4
x 2
Rear Fence
Rail
x 2
-21-