Grizzly G0771Z Manual page 66

6. Loosen (4) table mounting bolts securing
table top to base (see Figure 111), and lightly
tap table in direction needed to square table
to blade.
Mounting
Figure 111. Location of table mounting bolts
(table omitted for clarity).
7. Repeat Steps 2–6 until blade and miter
slot are parallel, then tighten retighten table
mounting bolts.
Tilt blade to 45° and recheck miter slot-to-
8.
blade parallelism.
— If blade is still parallel with miter slot, no
additional adjustments need to be made.
— If blade was parallel with miter slot at 0°
but not at 45°, one end of table will need to
be shimmed higher with metal shim stock.
Continue to Step 9.
9. Loosen (4) table mounting bolts from Step 6.
Model G0771Z (Mfd. Since 01/21)
Bolts
10. Refer to Figures 112–113 for shim place-
ment. If distance A is shorter than B, shim(s)
will need to be placed under corners #1 and
#2. If the distance of B is shorter than A,
shim(s) will need to be placed under corner
#3. Very thin shim stock works well.
STEP A
#1
Front
#2
Figure 112. Shim procedure diagram A.
STEP B
#1
Front
#2
Figure 113. Shim procedure diagram B.
#3
#3
-63-