Grizzly G0771Z Manual page 46

Components Needed:
Hex Nuts M6-1 ...............................................3–6
Flat Head Cap Screws M6-1 (length varies) ..3–6
Wood* ⁄ " x 4" x Length of Fence ......................1
3
4
*Only use furniture-grade plywood, kiln-dried
hardwood, or HDPE plastic to prevent warping.
To build an auxiliary fence:
1. Remove fence cap from fence face on
which you will mount auxiliary fence (see
Figure 69).
Upper T-Slot
Lower T-Slot
Figure 69. Auxiliary fence mounts on upper or
lower T-slots of fence face.
2.
Slide (3) M6-1 hex nuts into either the upper
or lower T-slot.
Note: For additional mounting strength,
attach auxiliary board with six hex nuts and
flat head cap screws using both T-slots.
3. Place auxiliary fence board against fence
face. Place a thin metal shim (such as a ruler)
between table and bottom of auxiliary fence
board to ensure adequate clearance between
fence board and table. Clamp in position.
Model G0771Z (Mfd. Since 01/21)
Fence
Cap
4. Measure depth of board plus depth of T-slot,
to determine maximum length of M6-1 flat
head cap screws needed to mount auxiliary
fence board to fence face.
5.
Measure centerline of fence T-slot and trans-
fer to auxiliary fence board to determine
where to drill holes in board for flat head cap
screws.
Auxiliary Fence
6.
Set auxiliary fence board aside, and using
⁄ " drill bit, drill mounting holes in auxiliary
1
4
fence board. Countersink holes
head of cap screw sits slightly beneath face
of auxiliary fence board.
7.
Insert cap screws through holes in auxiliary
fence board (see Figure 70).
8.
Align cap screw threads with hex nuts and
M6-1 Flat
tighten (see Figure 70).
Head Cap Screw
Figure 70. Example auxiliary fence attached to
included fence.
9.
Replace fence cap.
M6-1 Hex Nut
⁄ " deep so
1
16
Fence
Assembled Auxiliary Fence
-43-