Table of Contents
Advertisement
Combustion settings.
This allows for adjustment of the "pellet" quan-
tity and the "air flow"
Pellet
This feature allows the user to increase or
decrease by 25% the pellet quantity during the
start-up and power process. Press "set". The
display starts to flash. Press "+" or "-" to
increase or decrease (between -10 to +10), as
required. Each unit must be multiplied by 2.5 to
obtain the correct percentage.
Air
This feature allows the user to increase or
decrease by 25% the rotation speed of the
fume extractor during the start-up and power
stages. Press "set". The display starts to
flash. Press the "+" or "-" key to increase or
decrease (from -10 to
+10), as required. Each unit must be multiplied
by 2.5 to obtain the correct percentage. Press
"ok" to confirm.
Technical menu,
The technical menu is password protected, the
password is only provided to authorised techni-
cians.
Operation.
Start
After loading the pellets into the hopper , press
and hold the ON/OFF button for 3 seconds, to
start the stove. During the lighting phase, the
display will show the message "Ignition" (until
this
phase
The pellets are fed through the supply channel
to the burning pot (combustion chamber), where
they will be ignited using an igniter. This process
may take 5 to 10 minutes, depending on
whether the worm screw used to push through
the pellets has been previously filled or not.
Once the ignition phase is completed, the mes-
sage "On" appears on the display. The heating
power can be adjusted at any time by pressing
the power selection button for approximately 1
second. You can select from the five pre-set
power levels that are available. The selected
power is indicated on the display. The initial
power status at each start-up will correspond to
the power level set before the last stop.
Note Before starting the machine check that the
baffle
plate
is
is
completed.
correctly
positioned.
Shut down.
To turn off the pellet stove is carried out by
pressing the ON / OFF button for 3 seconds.
The display will show "shut down" until full
completion of this phase. The extractor will
operate until the fume temperature of 64ºC is
reached, to guarantee that all the material has
been burnt.
Note
Do not shut down the appliance by isolat-
ing the electrical supply .
CO ALARM
The fitting of CO Alarms in the same room as the
appliance is a compulsory requirement under cur-
rent Building Regulations. For ROI an additional CO
Alarm must be fitted either inside each bedroom or
within 5 metres of the bedroom door, refer to
Building Regulations Part J. Further guidance on the
installation of a carbon monoxide alarm is available
in BS EN 50292:2002 and from the alarm manufac-
turers instructions.
up.
16
Advertisement
Table of Contents
