Table of Contents
Advertisement
User Information
To access the user information.
press "set" twice and then press "+" until
" User Info is displayed"
press set to acess the "User info" then scroll
through the following list of parameters using
the "+" and "-".
Control board code.
Security code
Display code
Parameters
Functioning time/ run hours
Service time/ time since last service
Service time/ time to next service
Carrying out/ current status
Exhaust Fan -Rpm
Consumption pellets- kg/hr
Fumes/ Flue gas temperature
Pellet feed time
Ignitions number
Setting menu,
To access the "settings"
press "set" twice and then press "+" until "set-
tings" is displayed.
press "set" to acess the "settings" then scroll
through the following list of parameters using
the "+" and "-".
Language
Eco mode
Back light
Remote control
ºC/ºF
Combustion recipe
Language
To select the language, press "set".
Using the "+" or "-" keys, select the language.
En – English
Eco mode
When the "ECO" mode is enabled at the
same time as the Thermostat feature, the unit
will operate at maximum power until the ther-
mostat opens contact (NO). The unit then will
operate at minimum power for a pre-set period
of time (Shutdown delay time: factory setting:
20 minutes).
Once the pre-set time is elapsed, the unit
shuts down. At the start of the Shutdown
phase, another timer for a different pre-set
period of time is triggered (Start-up delay time:
factory setting: 20 minutes), that will make the
unit enter the activation phase, when the ther-
mostat closes contact (NC)
Start-up delay time (Delay time On): The
delay time that elapses between the moment
the thermostat closes (NC) until the unit is acti-
vated.
Shutdown delay time (Delay time Off): The
delay time that elapses between the
moment the thermostat opens (OC) until the
unit starts to shutdown.
Note: When using the feature for the first time,
you must press the On/Off button in the dis-
play. To enable the eco mode, press "set". The
display starts to flash. To activate the eco
mode, press "set". The display starts to flash.
Select "On" or "Off" using the "-" and "+" keys.
Press "set" to confirm the selection.
To Select " back light" , press "set". The display
starts to flash. Press the "+" or "-" key to select
the time for the screen to light up, or select
"On" to keep the light permanently on. Press
"ok" to confirm.
Remote Control.
This feature enables and disables the remote
control, when the user wants to operate the
unit's thermostat remotely. Press "Set" and use
the "+" and "-" keys to select the "On" or "Off"
mode. Press "Ok" to confirm. Press the "+" key
to go to the "temperature units" menu.
Note: Some TV remote controls share the
same frequency as the unit's remote control,
possibly influencing the unit's operation. If this
is the case, it is recommended to disable the
remote control feature.
ºC/ºF
To select ºC / ºF, press "set". The display starts
to flash. Press the "+" or "-" key to select "ºC",
"ºF" or "Auto", and then "ok" to confirm.
15
Advertisement
Table of Contents
