Setting The Programmer - Stanley K500 Installation And Operating Instructions Manual

Setting the Programmer.

The unit is equipped with a timer that allows
the unit to be turned on or off at specified
times.
This can be set up by loading one of 10 preset
profiles in the software P01- P10.
Alternatively the unit can be programmed man-
ually with up to 6 on/ off times per day.
Fig. 22
When the unit is set to switch on and off using
the programmer the display will flash between
the on/ off screen and a screen similar to
above.
To enable the timer press "set". The "enable"
menu is displayed. The timer may only be acti-
vated after setting the configurations, as shown
in the following paragraph..
Fig. 23
To activate the Timer mode, press "Set" the
display starts to flash. Press the "+" or "-" key
to select "On" or "Off" and then "Ok" to confirm.
Press the "+" key to scroll to the "Load profile"
menu.
Fig. 24
There are 10 weekly programmes available on
the Timer see " fixed timer schedules at the
back of the manual . The selected programme
runs from Monday to Friday and from Saturday
to Sunday.
Press "set"; the display starts to flash. Press
the "+" or "-" key to select the desired pro-
gramme and then press "ok" to confirm. Press
the "+" key to go to menu "Reset".
Press the "+" key to go to menu "Reset".This
menu allows you to delete any programme set-
tings. To do this, press "set". The "Confirm"
appears. Press "set" again to confirm that you
want to delete the settings or "esc" to exit.
Alternatively the unit's programmer lets you
choose from 6 different programmes for each
day of the week.
To set up programmes "P1" to "P6", select the
desired programme using the "-" and "+" keys,
and press "set" to select. The "P1 Enable"
menu appears.
To run a user set program P1 the timer/ chrono
must be enabled and also the program must
be enabled
Press "Set" again and when the display starts
to flash, press the "+" or "-" keys to select "On"
or "Off". Press "ok" to confirm the selection.
Press the "+" key to go to the "start" time.
13
Fig. 25
Fig. 26
Fig. 27