Cuisinart Smart Stick CSB-87C Instruction And Recipe Booklet page 10

WHISKING
1. Insert the whisk assembly into the motor body.
(See Assembly for Whisk Attachment, page 8.)
2. Plug electrical cord into a wall socket.
3. Put the whisk into mixture that will be blended.
4. Turn the variable speed control to the desired speed. To begin
whisking, follow the instructions in #5 under Blending, page 8.
5. Unplug immediately after use.
TO PULSE
1. Press and hold the LOCK/UNLOCK button.
2. Then press and hold the ON/OFF button.
3. Repeatedly press and release the ON/OFF button
while continuing to hold down the LOCK/UNLOCK button
to PULSE until ingredients reach desired consistency.
CHOPPING FOOD
1. Place the work bowl on a flat, sturdy surface like a countertop.
2. Assemble the stainless chopping blade into the chopper bowl, as
shown in Fig.1.
3. Put food in the work bowl. Be sure the food is cut into small
pieces [½ to 1 inch (1.25 to 2.5 cm)], and the bowl is not
overloaded.
4. Attach the lid onto the chopper bowl, place lid on the chopper
bowl and turn it in clockwise direction until it locks in position.
To remove lid, turn counter-clockwise.
5. To assemble the chopper with the motor unit, connect them and
lock into place.(See Fig.3)
6. Press the unlock button to unlock the unit and then press on/off
button to start. You can select desired speed setting by dialing
speed knob. The speed will be higher gradually when you dial
the speed control dial from left to right.
Note: Due to the powerful motor provided with this unit,
Cuisinart recommends using one hand to support the work
bowl during operation.
Note: Max operation duration per time should less than
1 minute, and 3 minute rest time must be maintained at
two consecutive cycles.
7. When you have finished processing the food, stop the machine
by taking your finger off the desired speed button.
8. WHEN THE BLADE STOPS MOVING
9. Remove the motor unit from the chopper lid by turning it in
anti-clockwise.
, unplug the unit.
10