Complete The Tv Configuration - LG 32LY770M Commercial Mode Setup Manual

Express Script (Cont.)

Complete the TV Configuration

The following procedure describes the remaining steps in the Express Script. You can select the
"BACK" button, where available, to check previous settings, as necessary. Typically, if you do
not modify the default settings, the "NEXT" button is automatically selected when you proceed
forward within the Express Script. Where appropriate, you can simply press OK on the Installer
Remote to proceed to the next step if the default value(s) for the TV parameter(s) in question are
applicable for your installation.
Note: If you choose to exit the Express Script from this point on, any settings made
will not be retained.
1. In the Select the Tuning Band screen, use the Up/Down arrow keys on the Installer Remote to
highlight/select the appropriate tuning band option: Cable Standard (default), Cable HRC, Cable
IRC, or Air. Then, press OK. When you have made your selection, use the arrow keys to select
NEXT, and then press OK.
SELECT THE TUNING BAND
Select the tuning band you would like to use:
Cable Standard
Cable HRC
Cable IRC
Air
2. By default, all Aux inputs are enabled, as shown initially in the Enable/Disable Aux Inputs
screen. To disable an Aux input, use the arrow keys on the Installer Remote to select the desired
input, and then use the Left/Right arrow keys to toggle the status value to DISABLED.
ENABLE/DISABLE AUX INPUTS
Enable/disable Aux inputs as required.
<
AV IN/Audio IN (DVI)
<
HDMI 1
<
HDMI 2
26
EXIT BACK NEXT
>
ENABLED
>
ENABLED
>
ENABLED
EXIT BACK NEXT
02
03
(Continued on next page)
206-4271