Complete The Tv Configuration - LG 22LY560M Commercial Mode Setup Manual

Express Script Installer Menu Wizard (Cont.)
(Continued from previous page)
2. In the Pro:Centric Mode field, use the Left/Right arrow keys on the Installer Remote to select
the appropriate Pro:Centric Application Mode—GEM, FLASH, or Configuration Only.
3. Once the fields are completed as required, you have two options:
• To proceed with TV configuration via the wizard, select Next and press OK on the Installer
Remote. See also "Complete the TV Configuration" below.
• To save the data entered and exit the wizard, select Done and press OK on the Installer
Remote. Remember, however, that if you bypass the Express Script, pillow speaker
functionality will not be enabled unless you set Installer Menu item 027 HOSPITAL MODE
appropriately. See the "Installer Menu" section of this document for further information.
Note: If you intend to use a TLX file for cloning or FTG Mode configuration purposes,
exit the Express Script at this time.

Complete the TV Configuration

The following procedure describes the remaining Express Script
Installer Menu Wizard steps. You can select the "Back" button, where
available, to check previous settings, as necessary.
Note: If you choose to exit the Express Script from this
point on, any settings made will not be retained.
1. Select the tuning band.
Use the Up/Down arrow keys on the Installer Remote to select the
tuning band field, and then use the Left/Right arrow keys to select
the appropriate tuning band: Cable Standard (default), Cable HRC,
Cable IRC, or Air. When you have made your selection, use the
arrow keys to select Next, and then press OK.
2. Select the Aux inputs.
If you simply select Next and press OK in this step, default values
will be used, i.e., all Aux inputs will be enabled. Otherwise, use the
Up/Down arrow keys on the Installer Remote to select the desired
Aux input option(s).
Note: If an Aux input will not be used, it is advisable to disable it.
After the TV setup is transferred to the PTC (see step 8), the only
way to remove Aux inputs from the channel lineup, is to go to the
Channel Preview/Banks Setup Menu and select Normal-Deleted.
• To customize settings, select Customize Inputs and press OK.
Aux input options are displayed in a pop-up window. Use the
arrow keys to select the input(s) to enable or disable. When you
are finished, press OK on the Installer Remote. Then, continue
with step 3.
Note: If you would like to return to the Aux Input screen, press
MENU to close the pop-up window.
• To use default values, select Use Default Values and press OK.
Then, continue with step 3.
14
Installer Menu Wizard
Step 1. Tuning Band
Which tuning band would you like to use?
Cable Standard
Back
PTC: V1.00.020 CPU: V03.11.00.01 ASIC: D279
Note: Typically, if you do not modify the default
settings, the "Next" option is automatically selected
when you proceed forward within the wizard.
Where appropriate, you can simply press OK on
the Installer Remote to proceed to the next step
if the default value(s) for the TV parameter(s) in
question are applicable for your installation.
Installer Menu Wizard
Step 2. Aux Input
Which inputs will you be using?
Customize Inputs
Use Default Values
Back
PTC: V1.00.020 CPU: V03.11.00.01 ASIC: D279
(Continued on next page)
1
► 2 ► 3 ► 4 ► 5 ► 6 ► 7 ► 8
Next
OK Exit
CC
2
1 ► ► 3 ► 4 ► 5 ► 6 ► 7 ► 8
Next
OK Exit
CC
206-4261