Configure Pro:centric Settings - LG 32LY770M Commercial Mode Setup Manual

Configure Pro:Centric Settings

Once you select "NEXT" from the TV Configuration Options screen, the Searching for Pro:Centric
Server screen is displayed.
Note: Select the "BACK" button, where available, to check previous settings, as necessary. Also
note that if any of the configuration steps fails, you will see a "Diagnostics" screen with an indication
of the failure. You will then have the opportunity to reinitiate the configuration process from the
previous screen or exit the EZ-Manager Wizard.
SEARCHING FOR PRO:CENTRIC SERVER...
It may take 2 min 51 second(s).
This step automatically searches for the Pro:Centric Server.
If there is no Pro:Centric server installed, you do not need to continue with this procedure.
Please select either EXIT or MANUAL PRO:CENTRIC.
Status: Tuning channel 30
TV is now searching the pre-defined channels for the data channel...
You have the following options:
• You can allow the EZ-Manager Wizard to proceed with a series of automated steps to configure
the TV for Pro:Centric operation and then to look for the Pro:Centric application and maintenance
(E-Z Installation) files to download. In this case, the wizard uses a search algorithm to determine
the Data Channel and the Pro:Centric Application Mode to set in the TV.
Continue with the "Automated Pro:Centric Configuration" subsection below.
• If you already know the settings (i.e., Data Channel and Pro:Centric Application Mode) that need
to be configured in order for the TV to connect to the Pro:Centric server and/or if the Pro:Centric
server is not yet installed, you may expedite the setup process by entering this data manually.
Continue with the "Manual Pro:Centric Configuration" subsection on page 19.
Automated Pro:Centric Configuration
Note: If the server is not yet configured on the system, use the manual configuration option to
configure the Pro:Centric operation. See also note below.
Note: If Pro:Centric data delivery will be over IP and there is a DNS server at the site, you can
create a DNS entry "procentric.local" for the Pro:Centric server that will enable automated
Pro:Centric IP configuration via the EZ-Manager. If there is no DNS entry for procentric.local, you
must use the manual configuration option to configure the Pro:Centric IP operation.
Once the Pro:Centric data channel is found (a Pro:Centric Server Was Found screen will be
displayed) and the Pro:Centric Application Mode is determined, the wizard will advance to the
Processing the Pro:Centric Configuration screen, which shows the progress of the data
downloads (see example on following page). Note that some steps may require a few minutes.
206-4271
BACK EXIT MANUAL PRO:CENTRIC
EZ-Manager Wizard (Cont.)
02
17