LG 32LY770M Commercial Mode Setup Manual page 30

Express Script (Cont.)
(Continued from previous page)
CHANNEL OVERRIDE
Do you want to allow access to channels that are not in the channel lineup?
< >
YES
7. As the final step of the Express Script, the TV saves your settings and transfers the auto-tuned/
edited channel lineup to the commercial controller (PTC). When you are ready to proceed, select
FINISH, and then press OK.
COMPLETE THE EXPRESS SCRIPT EZ-MANAGER CONFIGURATION COMPLETE
This step transfers the auto-tuned/edited channel lineup to the TV's commercial controller (PTC). Note that
the maximum number of channels (analog, digital, and Aux inputs) that can be transferred to the PTC is 141; any
extra channels will not be available in the PTC Channel Map. Aux inputs will appear between the highest analog
and lowest digital channel number in the PTC Channel Map.
If you did not run Auto Tuning, no analog or digital channels will be transferred to the PTC Channel Map upon
Pro:Centric Application
completion of this step. In this case, the only channels in the PTC Channel Map will be any enabled Aux inputs.
Maintenance Files
Select FINISH to complete the Express Script.
Saving data...
Configuration progress will be shown at the bottom of the screen. When this step is complete, the
Express Script exits, and the TV tunes to the first channel in the PTC Channel Map.
Note: If desired, you can clone the TV Setup created from the Express Script using a legacy
LT2002 or TLL-1100A clone programmer.
Note: If access to the channel lineup has been limited at the completion of the Express Script
(see step 6) and you would like to set up channel banks at a later time, you will need to set
Installer Menu item 028 CH. OVERIDE to 1 to enable access to the Channel Preview/Banks
Setup Menu. See pages 49 to 52 for further information on channel banks.
30
BACK
EXIT NEXT
Installed Components
GEM application downloaded
LYH_Config.tlx
EXIT BACK FINISH
REBOOT TURN OFF
07
50%
08
206-4271