Levelling Instructions; Moving The Table - OAKWORKS Clodagh Leo User Manual

DIRECTIONS FOR USE
L E V E L I N G I N S T R U C T I O N S
1. Place the table in the location where you plan to use it.
2. Rock the table to determine if it is level with the floor. If
the table rocks back and forth at all, the foot that clears
the floor when you rock the table will need adjustment.
3. Adjust the Leveler Foot by first loosening the locking
nut found just above the rubber Leveler Foot with the
1/2" open-end wrench.
4. Lower the adjustable rubber Leveler Foot until it meets
the floor snugly. Tighten the locking nut against the leg
of the table with the 1/2" open-end wrench to fix the
Leveler Foot in position.
5. Rock the table again to be sure adjustments have
stabilized the table. If necessary make any additional
adjustments in the same way.
M O V I N G T H E T A B L E
CAUTION
Never lift the table by grasping the table top as the table top is not designed to hold the
weight of the base and you could damage the table and the electronics that run the table top.
If you need to move the table, place one person at each corner of the table. We recommend that you
have the table top in the up position (with Arm Rests removed) to have the table top ends out of the
way as much a possible. Have each person firmly grasp the cabinet base at the bottom by the table
legs and lift the table from the base. As when moving any piece of heavy equipment, bend at the knee
and lift with your legs beneath you and not with your back. Be aware and use proper, safe procedures
for moving a table of this size to prevent injury to yourself or the table. We strongly recommend that
a flatbed dolly be used that can hold the entire table if moving the table involves any large distance.
Before moving the table, disconnect the power cord from the power outlet. Secure the power cord and
all hand or foot controls before moving. The table weighs as much as 260 lbs. (118 kg.) Four people
are required to move the table safely.
Position at lowest height
Leveler Foot
1/2" Open-end
Grasp
at base
corner
Wrench
8