Logging Switch; Logged Channels - Racelogic VBOX Touch Getting Started

Logging Switch

It is also possible to control logging by using an RLVBACS010 hand-held latching trigger switch (unlatched for logging/
latched for not logging). Continuous Logging Mode
pin Digital In and PPS Connector
When the trigger switch is connected and latched, it is not possible to use the
logging data.

Logged Channels

VBOX Touch logs channels to an inserted SD card within a
• Satellites: This is the number of satellites in use.
• Time: This is UTC time since midnight in the form HHMMSS.SS.
• Latitude: Latitude in minutes MMMM.MMMMMMMM +ve = North e.g. 3169.30644410M = 52D, 49M, 18.4S.
• Longitude: Longitude in minutes MMMMM.MMMMMMMM +ve = West e.g. 00040.18164742M = 00D, 40M, 10.9S.
• Velocity: Velocity in km/h.
• Heading: Heading in degrees with respect to North.
• Height: Height above sea level in meters based on the
• Vertical velocity: Vertical velocity in km/h. +ve velocity uphill, -ve velocity downhill.
• Long accel: Longitudinal acceleration in g, +ve for forward acceleration.
• Lat accel: Lateral acceleration in g, +ve for acceleration to the left.
• Solution type: Indicator for what the unit is currently using to derive position: 0 = No sats; 1 = Standalone
using GNSS only; 2 = SBAS; 3 = RTK Float (RTK but not full resolution); 4 = RTK Fixed.
• Event 1 time: This is the digital input oversample timer used to interpolate the trigger event time between captured
samples.
• Correction age (VBOX Touch RTK only): RTK signal age in seconds, if there is a loss in connection, the value
resets at 60 s.
• GPS Sats Used (VBOX Touch RTK only): Number of GPS satellites in use.
• Glonass Sats Used (VBOX Touch RTK only): Number of Glonass satellites in use if selected within the
Selection area within the General Settings menu.
• Beidou Sats Used (VBOX Touch RTK only): Number of Beidou satellites in use if selected within the
Selection area within the General Settings menu.
• Galileo Sats Used (VBOX Touch RTK only): Number of Galileo satellites in use.
More information on the VBO file format can be found here.
should be selected when using the switch. It is connected to the 3
on the side of the VBOX Touch.
https://en.racelogic.support//Product_Info/VBOX_Data_Loggers/VBOX_Touch/VBOX_Touch_User_Guide/02_-
SD Card Icon
.vbo file, channel information is available below:
WGS84 model of the earth used by VBOX GNSS engines.
to manually start or stop
GNSS
GNSS
_VBOX_Touch_Getting_Started
8