Table of Contents
Advertisement
All manuals and user guides at all-guides.com
DF500 Folder Operator Guide
Error Messages Displayed on the Control Panel (continued)
Error Message
Jam In Folder
Open Top Cover
Jam In Stacker
Done Enter
Limit Switch F.P.1
Or
Limit Switch F.P.2
Motor Stopped
Open Top Cover
Programs Full
Clear Job First
38
What It Means
A paper jam has occurred
within the machine.
A folded sheet has not
been ejected properly
onto the stacker table. It
is usually caused by paper
piling up when the stacker
table is full or by a double
sheet. In rare cases, with
certain types of paper,
it can also happen when
a folded sheet catches
the topmost panel of the
preceding sheet. The
sheet causing the jam will
probably look like this: Z
or like this: Z
The stop in either fold
plate 1 (F.P.1) or fold plate
2 (F.P.2) has moved to
the very end of its travel
and has operated the
emergency limit switches
at those positions.
A large paper jam caused
the motor to stall. The
internal electronic control
in the DF500 will shut
down the motor and
display this message.
You have attempted to
save a new job but all nine
memory locations are
already full.
Operator Action
Refer to "Clearing a jam"
on page 32 and "Removing
the fold plates" on page
33.
• Remove all paper from
the stacker table,
then press Enter. The
stacker wheels will
return to their operating
position and the display
will show operating
mode again.
• Open the top cover
and remove any paper
inside. Close the top
cover and press Enter
to clear the display
message.
• If possible, adjust the
fold to look more even
like this: Z
Follow the procedure for
"FOLD PLATE ERROR"
above to clear this
condition.
Refer to "Clearing a jam"
on page 32 and "Removing
the fold plates" on page
33.
Delete some jobs to make
room (see page 27).
SV40214 Rev. A
Advertisement
Table of Contents
