Soft Reset; Hard Reset - Directed Directechs DS3+ Installation Manual

Soft reset

A module reset will only erase the steps perfomed in "Module Programming". The firmware and settings flashed to the module will
not be affected.
If required for your installation, connect all the harnesses to the module, EXCEPT the 12-pin
1
main power harness. Press and hold the programming button, then connect the 12-pin
harness to the module.
DS3+: Wait 3 seconds until the LED turns ON solid orange then release the programming
button. The LED turns ON solid red.
2
DS4+: Wait 3 seconds until the LED turns ON solid orange then release the
programming button. The LED turns ON blue for 1 second then solid red.

Hard reset

Warning Against Executing a Hard Reset!
A hard reset will revert the flashed firmware back to its default factory settings. Depending on the installation, some settings
may need to be reconfigured. Connect your module to a computer and use the web configuration tool to edit its programmable
features.
If required for your installation, connect all the harnesses to the module, EXCEPT the 12-pin
1
main power harness. Press and hold the programming button, then connect the 12-pin
harness to the module.
After 3 seconds the LED turns ON solid orange. Keep holding the programming button until
2
the LED flashes red, then orange slowly.
DS3+: Release the programming button. The LED turns solid red.
3
DS4+: Release the programming button. The LED turns ON blue for 1 second then solid
red.
18
933.VW08 1.39.195.3 2019 Audi Q8 (Smart Key)
©2021 VOXX•DEI LLC. All rights reserved.
Connect all but the
12-pin harness
& &
Solid
Release
& & &
Solid
Solid
Release x1 Sec
Connect all but the
12-pin harness
&
Solid
Hold
&
Release
& &
Solid
Release x1 Sec
Solid
Solid
&
Flashes
Solid
Solid