Table of Contents
Advertisement
A. Protocol
Use the up and down arrow keys to move the yellow cursor to the "protocol", set corresponding Protocol
and support more than thirty PTZ protocols. Such as Pelco-D, Samsung, Yaan, LiLin, CSR600, Panasonic,
Sony-EVI etc.
B. Port
Click and move, to "port" Select the communication port for the PTZ camera controlling (RS485)
C. Baud
Move the yellow cursor to "Baud", Select the baud rate according to baud rate of the PTZ camera. (150 / 300
/ 600 / 1200 / 2400 / 4800 / 9600 / 19200 / 57600 / 115200)
D. Address
Set the ID according the ID of PTZ camera (0~254), the setting address data must be consistent the speed
dome address.
E. Pan speed: Set the pan speed of PTZ camera (0~63)
F. Tilt speed: Set the tilt speed of PTZ camera (0~63)
G. Set preset position (Set PS)
Click and select "Set PS", set and save preset position number (1~128),
H. Call the preset position (Go PS)
Click and select "Set PS", set and save preset position number (1~128), click "sure" to save,
Call some special preset number, can call the dome camera menu
Check and set the protocols, address, interface and baud, all must be consistent with the dome camera, then
- 34 -
Advertisement
Table of Contents
