Table of Contents
Advertisement
2) If use the tester's menu to turn off the tester's PoE power supply, the PoE switch and the power
sourcing equipment are allowed to connect to the tester's PSE port, and the PoE power will be
supplied to the IP camera by the tester's LAN port. On this condition, the tester cannot receive data
from IP camera, but the computer connected to the PoE switch can receive the data via the tester.
Warning: Poe switch or PSE power sourcing equipment only can be connected to tester "PSE
IN" port, otherwise will damage the tester.
3.2.2 Analog camera connection
Connect the camera's video output to the IP tester's VIDEO IN. The image will display on the
(1)
tester after pushing the PTZ icon
(2) CCTV IP Tester "VIDEO OUT " interface connect to the Video input of monitor and optical video
transmitter and receiver, the image display on the tester and monitor
(3) Connect the camera or the speed dome RS485 controller cable to the tester RS485 interface.
(Note positive and negative connection of the cable).
- 9 -
Advertisement
Table of Contents
