Table of Contents
Advertisement
The IP tester supports PoE (Power over Ethernet) output to an IP camera via the LAN port. Data transmission
and 48VDC use the network cable's 1, 2, 3, and 6 pins to deliver power. If the IP camera supports PoE, you can
directly connect to the camera without the use of an external power supply.
Notice
a. Please make sure the cable connected to the tester's LAN port is straight-line cable and has no short circuit,
otherwise will damage the tester
b. Before using PoE power output, please check the IP camera whether supports POE powered. Otherwise it
will damage the IP camera.
c. The instrument's PoE maximum power output is 24W. If Ultra- high-power load happens, the tester will
enter protection mode.
3.6 DC12V 2A power output
When the IP tester is turned on, the DC 12V power output ON by default. The smaller end of the supplied
converter cable connects to the tester's DC12V/2A OUTPUT and the other end connects to the camera's
power input.
- 102 -
Advertisement
Table of Contents
