Table of Contents
Advertisement
Available languages
Available languages
Erasing a program
You can erase the contents of the memory by:
opening the CD door;
-
Slide the function selector to Radio or OFF mode;
-
In the STOP mode, press PROG and then press STOP.
-
Notice for CDR/CDRW users:
Depending on the type of CD burner, on the disc brand and the burning speed, some reading
problems may occur.
MAINTENANCE & SAFETY
Precautions & General Maintenance
CD/MP3 player and CD handling
•
The lens of the CD player should never be touched!
•
Sudden changes in the surrounding temperature can cause condensation to form
and the lens of your CD player to cloud over. Playing a CD is then not possible.
Do not attempt to clean the lens but leave the set in a warm environment until the moisture
evaporates.
•
Always close the CD door to keep the CD compartment dust-free.
To clean, dust the compartment with a soft dry cloth.
•
To clean the CD, wipe in a straight line from the centre towards the edge using a soft, lint-free
cloth. Do not use cleaning agents as they may damage the disc.
•
Never write on a CD or attach any stickers to it.
•
Place the set on a hard and flat surface so that the system does
not tilt.
•
Do not expose the set, batteries or CDs to humidity, rain, sand
or excessive heat caused by heating equipment or direct sunlight.
•
Do not cover the set. Adequate ventilation with a minimum gap
of 6 inches between the ventilation holes and surrounding surfaces
is necessary to prevent heat build-up.
•
The mechanical parts of the set contain selflubricating bearings
and must not be oiled or lubricated.
•
To clean the set, use a soft dry cloth. Do not use any cleaning
agents containing alcohol, ammonia, benzene or abrasives as these
may harm the housing.
ENG - 39
ENG
Advertisement
Table of Contents
