Maintenance Schedule; Grease Points - Wallenstein WX540 Operator's Manual

Service and Maintenance

7.3 Maintenance Schedule

Perform maintenance procedures at time shown or hour
interval, whichever comes first.
As Required
Check the condition of all hydraulic lines, hoses and fittings.
Replace any that are damaged.
Remove any entangled material from splitter.
Check that all fasteners are tight.
Every 8 hours or Daily
Check fuel level
Check engine oil level.
Every 40 hours or Annually
Check hydraulic oil level.
Clean engine air filter
Inspect hydraulic oil quality
Grease frame slide, hinges, pivot
points
Every 100 hours or Annually
Grease axle bearings
Change engine oil
Check tire pressure
Change hydraulic oil and filter
Change engine air filter
Clean machine. Remove debris
and entangled material.
Change fuel filter

7.4 Grease Points

Use a hand-held grease gun for all greasing. Pump one shot
of grease per fitting.
• Wipe grease fitting with a clean cloth before greasing to
• If fittings do not take grease, remove and clean them
See page 26
See page 25
See page 25
See page 26
See page 25
See page 34
See page 34
See engine manual
See rating on tire
sidewall
See page 36
See page 26
—
See engine manual
34
Look for this decal on your machine. It
indicates a grease point and the interval in
hours.
avoid injecting dirt and grit.
thoroughly. Replace grease fittings as necessary.
WX540, WX540L
Trailer Wood Splitter