Engine Oil Level Check; Hydraulic Oil Level Check - Wallenstein WX540 Operator's Manual

WX540, WX540L
Trailer Wood Splitter

6.5 Engine Oil Level Check

Check engine oil level daily.
Check with the machine parked on level ground and the engine
stopped.
IMPORTANT! Running the engine with a low oil level can
cause engine damage that is not covered by warranty.
1. Remove the oil level dipstick and wipe it clean.
2. Fully insert the oil level dipstick, then remove it to check the
oil level. The proper level is when the oil is visible at the
full (upper) mark on the dipstick.
3. If the oil level is low, add oil until the level is at the full mark.
SAE 10W-30 is recommended for general use.
4. Reinstall the oil level dipstick.
Fig. 15 – Engine Oil Level check
1. Oil Level Dipstick
2. Oil Filler
Refer to the engine owner's manual included in the manual
tube for further information on engine oils.

6.6 Hydraulic Oil Level Check

Check hydraulic oil level every 40 hours or weekly.
Check with the machine parked on level ground and the engine
stopped.
The proper level is when the oil is visible at the full (upper)
mark on the dipstick.
1
2
IMPORTANT! Do not operate machine if oil level is not
visible on the dipstick. Damage to the pump and other
components can occur.
Do not overfill the tank past the full mark.
Always check oil levels after changing filters or servicing
hydraulic components.
Hydraulic oil quality should be inspected every 40 hours. If
the oil is dirty or smells burnt, it should be replaced.
Be aware of high oil temperatures. Temperatures higher
than 180 °F (82 °C) could cause seal damage and degrade
oil quality.
6.6.1 Hydraulic Oil – Adding
00197
The hydraulic system uses Dexron® III ATF.
1. Clean the area around filler cap and remove it.
2. Use a clean funnel and add oil until the level is at the full
mark on the dipstick.
3. Install filler cap securely. Wipe up any spilled oil.
25
Operating Instructions
Fig. 16 – Hydraulic Tank Oil Level Dipstick
00638