Connecting A Tow Vehicle - Wallenstein WX540 Operator's Manual

WX540, WX540L
Trailer Wood Splitter
8. Ensure the stability jacks are raised and secured with the
latch pin.
9. Make sure tow vehicle is fitted with the correct size (2 in)
towing ball.
10. Make sure fuel and hydraulic tank caps are on tight to
prevent spills while transporting.
11. Clean all debris off the splitter. Remove any tools or other
loose items.
12. Check that all the lights, reflectors and other lighting
requirements are installed and in good working condition.
13. Never allow riders on the machine.
14. Be a safe and courteous driver. Always yield to oncoming
traffic in all situations, including narrow bridges,
intersections, and so on.
15. Watch for other traffic when near or crossing roadways.
16. Do not drink and drive.
17. Before transporting, perform a walk-around inspection to
ensure everything is safe.
6.14.2 Prepare for Transport
• Make sure the pivoting main frame is fully lowered to
horizontal. The lock pin in the pivoting splitter beam must
be fully engaged.
Fig. 31 – Lock Pin Fully Engaged
• Turn the fuel OFF when transporting.
Fig. 32 – Fuel Valve OFF
• Clean all debris from the splitter that could fall off in
transport.
• Check tire pressure. Inspect for cuts or damaged rims.
• Check lug nuts and re-torque as necessary. Inspect again
after 20–25 mi (32–40 km). Check weekly. See page 41.
• Inspect and replace any axle dust caps that are missing,
damaged or leaking.
• Always be in compliance with all applicable local
regulations when transporting.

6.15 Connecting a Tow Vehicle

1. Keep bystanders are clear of the machine.
2. Make sure there is enough room and clearance to safely
back up to the machine.
3. Slowly back the tow vehicle until the coupler on the hitch
and ball are aligned.
00650
4. Lift the hitch and place the coupler over the ball on the
hitch.
5. Flip the latch to lock the coupler around the ball.
6. Pull out the jack stand snap lock pin and raise the jack
stand to its stowed position. Install snap lock pin to secure
it.
7. Raise the rear jack stand and secure with the snap lock pin.
8. Cross safety chains under trailer tongue and attach
securely to the tow vehicle hitch.
9. Connect the wiring harness for the lights (as equipped).
10. Reverse the above procedure when unhooking.
00278
31
Operating Instructions
Fig. 33 – Ball Hitch Aligned
00207