Table of Contents
Advertisement
Transport
7. Transport
IMPORTANT! Equipment that is transported on a public
roadway must comply with the local laws that govern the
safety and transport of machinery.
The machine is not intended for use or transport on public
roadways. Therefore, it does not include the required lights,
reflectors, and markings.
Before taking the machine on a public roadway, install
the required lighting, reflectors, and markings, and make
sure that they are in good working condition. For specific
requirements, contact your local transportation authority.
7.1 Transport Safety
• Make sure that the machine is safely attached to the tow
vehicle with a retainer through the hitch.
• Always attach the safety chains between the machine and
the tow vehicle.
• Do not let people ride on the machine.
• Do not exceed a safe travel speed. Decrease your speed for
rough terrain and around corners.
• Plan your route to avoid heavy traffic.
• Do not transport or move the machine with the engine on.
• Inspect wheel rims for dents or damage, and tighten
the wheel lug nuts to the specified torque. For more
information, see Lug Nut Torque on page 44
• Inspect the tires for cuts or damage.
• Make sure the tires are filled to the specified pressure. For
correct tire pressure, see the tire sidewall.
• Make sure the tow vehicle is fitted with the correct size ball-
mount hitch (2 inches).
• Secure all guards, shields, and covers.
• Make sure that all fuel and hydraulic tank caps are installed
and secure (to prevent spills during transport).
• Remove all debris from the machine.
• After the machine is prepared for transport, complete a
circle check to make sure everything is safe.
•
7.2 Prepare for Transport
• Lift the log lifter shelf to its highest position and retract the
shelf arm.
• Stop the engine before transport.
• Clean all debris from the splitter that could fall off in
transport.
• Check tire pressure. Inspect for cuts or damaged rims.
• Check lug nuts and torque as necessary. Inspect again after
20–25 mi (32–40 km). Check weekly. See page 44.
• Inspect and replace any axle dust caps that are missing,
damaged or leaking.
7.3 Connect to a Tow Vehicle
1. Keep bystanders away from the machine and tow vehicle.
2. Make sure there is enough room and clearance to safely
back up to the machine.
3. Slowly back the tow vehicle until the coupler on the hitch
and ball are aligned.
4. Lift the hitch and place the coupler over the ball on the
hitch.
5. Flip the latch to lock the coupler around the ball.
6. Pull out the jack stand snap lock pin and raise the jack
stand to its stowed position. Install the snap lock pin.
7. Lift the rear jack stand and attach it with the snap lock pin.
8. Cross the safety chains under the trailer tongue and attach
them to the tow vehicle hitch.
9. Reverse the above procedure when disconnecting from the
tow vehicle.
Figure 22 – Attach to a tow vehicle
30
WX900 Series
Log Splitter
00716
Advertisement
Table of Contents
