Function Introduction; Power -Resuming Capability - Geeetech A30 User Manual

7 Function introduction

7.1 Power -resuming capability

A30 has the power loss-resuming capability. When power recovery starts, it will pop up a dialog
to ask if continuing the unfinished print caused by power outage, choose "Yes" and it will resume
printing. See picture (8-1).
When it reaches the target temperature, the X and Y axes will auto home. The extruder will
extrude the residue in the nozzle. Use a tweezers to clean the nozzle before starting printing
again.
Note:
1. When power outage, move the nozzle away from the printing model in case the filament
oozes out on to the print. In case the filament in the nozzle overflow due to gravity, causing
the model to have extra filament in the power-off position.
2. In order to ensure no obvious defects on the surface of the model after power-resuming. Be
sure to clean the residue with tweezers in the nozzle before restarting the print, or it would
affect the quality of the print.
Shenzhen Getech Technology Co.,Ltd
(Picture 7-1)
45