Table of Contents
Advertisement
REPLACEMENT OF THE INjECTORS
If the injectors are not supplied they can
be obtained from the "Service Centre".
Select the injectors to be replaced according
to the "TABLE fOR ThE ChOICE Of ThE
INjECTORS".
The
nozzle
diameters,
hundredths of a millimeter, are marked on
the body of each injector.
REPLACEMENT
INjECTORS OF THE COOKTOP
BURNERS
To replace the injectors proceed as follows:
•
Remove pan supports and burners
from the cooktop.
•
Using
a
wrench,
injectors "j" (figs. 2.4a, 2.4b) with
those most suitable for the kind of gas
for which it is to be used.
•
After having modified the injectors, the
gas regulation label (at the bottom of
the appliance) shall be replaced by the
new label supplied together with the
injectors gas conversion kit.
The burners are conceived in such a
way so as not to require the regulation
of the primary air.
SETTING THE MINIMUM OF THE
COOKTOP BURNERS
In the minimum position the flame must
have a length of about 4 mm and must
remain lit even with a quick turn from the
maximum position to that of minimum.
The flame adjustment is done in the
following way:
•
Turn on the burner.
•
Turn the tap to the 'MINIMUM' position.
•
Take off the knob.
•
With a small flat screwdriver turn the
screw "A" to the correct regulation (fig.
2.5).
Normally for LPG (G30 50mbar), tighten
up the regulation screw.
expressed
in
OF
THE
substitute
the
Semi-rapid
and rapid
burners
Triple-ring
burner
J
Fig. 2.5
J
Fig. 2.4a
Fig. 2.4b
19
Advertisement
Table of Contents
