Page 1
Service Procedures for the Model MLG33 Dryer Hot Surface Ignitor Gas Whirlpool Corporation Commercial Laundry Benton Harbor, MI 49022 1-800-662-3587 Part No. 450266-2...
Page 2
The illustrations included in this manual may not depict your particular dryer exactly. IMPORTANT For your convenience, log the following information: MLG33 DATE OF PURCHASE _____________________________________________________ MODEL NO. ____________________ DISTRIBUTOR’S NAME ___________________________________________________________________________________ SERIAL NUMBER(S) ______________________________________________________________________________________...
Table of Contents IMPORTANT You must disconnect and lockout the electric supply and the gas supply or the steam supply Part Locations and Removal ....4 before any covers or guards are removed from the machine to allow access for cleaning, Lower Front Panel Removal .........
Tilt the top of the panel out, disconnect electrical connection to computer panel, lift panel and unhook First remove the back guard, the four screws holding support brackets. top cover. Next pull top cover toward the rear of the dryer and lift up. Maytag Co. 450266 - 2...
EXHAUST HI-LIMIT To remove motorized impellor assembly, remove lint housing cover, lint screen, and the four screws shown with arrows. Pull the motorized impellor assembly out through the opening. 450266 - 2 Maytag Co.
The rear right wheel GAS VALVE requires removing the back guard, heat duct, and oven. Be sure to mark the position of rear wheel brackets prior to removal (refer to page 7). Maytag Co. 450266 - 2...
Below, both wheel assemblies are adjusted correct replacing the tumbler back into it’s original position and spacing is even on all sides. when the wheel brackets are reinstalled. 450266 - 2 Maytag Co.
BIT, belt will then wrap under motor sheave (Fig. 3). Remove BIT from dryer (Fig. 4). Next, you want to rotate basket slowly to ensure it is on the sheave completely. Tighten the motor adjustment nut to FIG. 4 position previous set. Maytag Co. 450266 - 2...
Temperature probe and exhaust hi-limit are accessible without the lint box being removed. The lint drawer switch can be removed after the lint box is and the cover has been removed. LINT DRAWER SWITCH TEMPERATURE PROBE EXHAUST HI-LIMIT 450266 - 2 Maytag Co.