Ignitor Probe Assembly Removal; Flame-Probe Removal; Rotation Sensor Removal; Basket/Tumbler Support Removal - Maytag MLG-45 Service Manual

Ignitor Probe Assembly Removal

Remove the back guard, disconnect the orange boot from
the DSI module by simply pulling off.
Remove the one Phillips head screw that is holding the ignitor
probe to the ignitor bracket.
Remove black plastic ring protector from the ignitor bracket
and remove ignitor and wire from the machine.
450386 - 1

Flame-Probe Removal

Remove the back guard, disconnect the white single
connector on the flame-probe.
Remove the one Phillips head screw on top of the ignitor
bracket holding the flame-probe. Pull the probe up and out
of the machine.

Rotation Sensor Removal

Remove the bottom nut on the rotation sensor. Lift the
rotation sensor up and through the hole in the bearing box.
Disconnect the rotation sensor two pin connector. Remove
from the machine.

Basket/Tumbler Support Removal

Maytag Co. 7