Related Manuals for Maytag MLG-45
Summary of Contents for Maytag MLG-45
- Page 1 MLG-45 Service Manual Maytag Co. Benton Harbor, MI 1-800-662-3587 Part No. 450386 - 1...
- Page 2 The illustrations included in this manual may not depict your particular dryer exactly. IMPORTANT For your convenience, log the following information: MLG-45 DATE OF PURCHASE ________________________________________________ MODEL NO. _____________________ DISTRIBUTOR’S NAME _______________________________________________________________________________ SERIAL NUMBER(S) __________________________________________________________________________________...
-
Page 3: Table Of Contents
The dryers must not be installed or stored in an area where it will be exposed to water and/or weather. The wiring diagram for the dryer is located in the front electrical control box area. 450386 - 1 Maytag Co. -
Page 4: Parts Locations And Removal
Unlock the lint drawer (if equipped with a lock) pull out the lint drawer 3/4 out, under the lint drawer is a rocker type locking mechanism push up on one end of this rocker type lock and remove it completely. Maytag Co. 450386 - 1... -
Page 5: Door Switch Removal
Lift up and pull out the panel about 8-inches or so. Disconnect the door switch wires (yellow wires) from the connector, connected to the connector on the side of the wrapper. Totally remove the panel from the dryer. 450386 - 1 Maytag Co. -
Page 6: Burner Hi-Limit Removal
Remove the upper 18” pulley belt. Loosen the two setscrews on the 18” main pulley. Remove the pulley. Install new pulley in reverse make sure the setscrews on the new 18” pulley are tight. Maytag Co. 450386 - 1... -
Page 7: Ignitor Probe Assembly Removal
Basket/Tumbler Support Removal Remove the one Phillips head screw that is holding the ignitor probe to the ignitor bracket. Remove black plastic ring protector from the ignitor bracket and remove ignitor and wire from the machine. 450386 - 1 Maytag Co. -
Page 8: Check Tumbler
This should be equal on the left-hand and right- drying. hand side. Maytag Co. 450386 - 1... -
Page 9: Motor/Impellor Removal
____________________________________________________________ the motor shaft. Remove the bolts holding the motor and install on new ____________________________________________________________ motor. Remove pulley from old motor and install on new motor. ____________________________________________________________ ____________________________________________________________ ____________________________________________________________ ____________________________________________________________ ____________________________________________________________ ____________________________________________________________ ____________________________________________________________ ____________________________________________________________ 450386 - 1 Maytag Co. - Page 10 Part No. 450386 1 - 11/04/08 - 0...
Need help?
Do you have a question about the MLG-45 and is the answer not in the manual?
Questions and answers