Mec 1330SE Service & Parts Manual page 25

Secton 10 - Mantenance
Drive Speed - Stowed
Proper drive functions are essential to safe machine operation. The drive function should respond
quickly and smoothly to operator control. Drive performance should also be free of hesitation, jerking
and unusual noise over the entire proportionally controlled speed range.
Perform this procedure with the machine on a firm, level surface that is free of obstructions.
1. Create start and finish lines by marking two lines on the ground 40 ft /12.2 m apart.
2. Turn the key switch to platform control and turn the red Emergency Stop button clockwise to the
"ON" position at both the ground and platform controls.
3. Lower the platform to the stowed position.
4. Press the drive function select button.
5. Choose a point on the machine; i.e., contact patch of a tire, as a visual reference for use when
crossing the start and finish lines.
6. Bring the machine to top drive speed before reaching the start line. Begin timing when your
reference point on the machine crosses the start line.
7. Continue at full speed and note the time when your reference point on the machine passes over
the finish line. The time should be 9-11 sec.
Drive Speed - Raised
Proper drive functions are essential to safe machine operation. The drive function should respond
quickly and smoothly to operator control. Drive performance should also be free of hesitation, jerking
and unusual noise over the entire proportionally controlled speed range.
Perform this procedure with the machine on a firm, level surface that is free of obstructions.
1. Create start and finish lines by marking two lines on the ground 40 ft /12.2 m apart.
2. Turn the key switch to platform control and turn the red Emergency Stop button clockwise to the
"ON" position at both the ground and platform controls.
3. Press the lift function select button.
4. Press and hold the function enable switch on the joystick.
5. Raise the platform approximately 4 ft /1.2 m from the ground.
6. Press the drive function select button.
7. Choose a point on the machine; i.e., contact patch of a tire, as a visual reference for use when
crossing the start and finish lines.
8. Bring the machine to top drive speed before reaching the start line. Begin timing when your
reference point on the machine crosses the start line.
9. Continue at full speed and note the time when your reference point on the machine passes over
the finish line. The time should be 35-40 sec.
Drive Speed - Slow
Proper drive functions are essential to safe machine operation. The drive function should respond
Page 21
Maximum Braking Distance
High Speed on paved surface
1330SE - Servce & Parts Manual
24 in ± 11.8 in
61 cm ±30 cm
November 2021