Removing An Electronic Module; Changing An Electronic Module During Operation - Pilz PSSu E F 4DI Operating Manual

Installation
5.3.2

Removing an electronic module

Procedure:
} Press the locking mechanisms [1] together simultaneously.
}
Pull out the electronic module [2].
Schematic representation:
5.3.3

Changing an electronic module during operation

It is possible to change an electronic module during operation. The configuration data is re-
tained when a module is changed.
Effects:
}
System environment A:
–
}
System environment B:
–
–
Operating Manual PSSu E F 4DI(-T)(-R),
21310-EN-08
In the event of a potential FS communication error, the FS section of the PSSu sys-
tem and all relevant I/O-Groups (SafetyBUS p) switch to a STOP condition.
All FS hardware outputs on the PSSu system switch to a safe condition.
The substitute values are used for the modules' FS outputs, with Valid Bits =
FALSE.
CAUTION!
Sparking can cause interference and errors!
Only change the module when the load is switched off!
[1]
[2]
[1]
19