Fig. 15 Mapping In The Interbus Coupler - Example For Kl4002 - Beckhoff KL400 Series Documentation

• KL4001: 2 bytes of output data
• KL4002: 4 bytes of output data
• KL4004: 8 bytes of output data
Parameterization via the fieldbus is not possible. If the control and status byte is to be used, the KS2000
configuration software is required.
Fig. 15: Mapping in the Interbus coupler – example for KL4002
Other Bus Couplers and further information
Further information about the mapping configuration of Bus Couplers can be found in the Appendix of the
respective Bus Coupler manual under Master configuration.
The chapter on Mapping in the Bus Coupler [} 28] contains an overview of possible mapping
configurations, depending on the configurable parameters.
Parameterization with KS2000
The KS2000 configuration software can be used for parameterizations via the serial inter-
face of the Bus Coupler, independent of the fieldbus system.
Note
KL400x Version: 4.0
Access from the user program
27